Plumbing Connections - Follett SmartGATE Ice Shield ITS500-31 Manual De Instalación, Funcionamiento Y Piezas

Sealing bin interior
!
The joint between base and bin sections must be sealed with silastic to prevent leakage and/
or ice contamination and potential voiding of warranty. One or more shutter doors may need
to be removed to seal bin.
1. Support shutter door(s) with one hand and remove thumbscrews from side of shutter door(s) at underside
of base.
2. Pivot door(s) downward to remove.
3. Gain access through this opening and seal entire perimeter of seam between bin and base with provided
sealant or equivalent.
4. After sealant has set but before shutter door(s) have been reinstalled, clean inside of bin following instructions in
this manual.
5. Reinstall shutter door(s) .
Use sealant provided to seal entire
perimeter of seam where base and
bin section join.

Plumbing connections

Note: It is recommended that a full width grated floor drain be installed in front of bin.
1. Units are shipped for a right side exiting drain. To drain to left, switch positions of screws in trough brackets
from lower hole to upper hole on left bracket and upper hole to lower hole on right bracket.
2. Remove plug from left side of drain trough and insert in right side.
3. Connect drain line to 1 1/4" PVC slip fit drain fitting.
4. Make final connections to icemaker.
Affixing operating labels
Operating labels taped to base front educate staff to shutter door operation. If desired, these labels can be affixed
permanently by peeling off back paper and affixing in locations desired.
Note: Adhesive backing is extremely strong and labels cannot be easily removed once installed.
Removing lower door assembly
(only if required for access through narrow doors)
1. With lower access door closed remove Phillips
head screw and washer from hinge area on each
side of lower access door.
2. Insert screwdriver between door and hinge bracket
on one side of door and gently push against bracket
to provide room for door stud to clear bracket.
3. Remove access door.
4. Pull up on SmartGATE to remove.
5. Remove three or four (3 or 4) screws along top of
door assembly.
6. Pull forward on assembly and remove.
Cross section of ITS sections joined
bin
exterior
section
base
section
access
door
SmartGATE
lower door
assembly
5
interior
completely
seal gasket