Craftsman 580.752300 Manual Del Propietário página 6

Ocultar thumbs Ver también para 580.752300:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Yourpressure w asher requires someassembly a ndis
ready foruseonlyafterit hasbeenproperly serviced
withtherecommended oilandfuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
1.
Open carton and slice two corners opposite guide
handle from top to bottom so panel can be folded
down fiat.
2.
Remove fillers, accesories and parts bag shipped
with your pressure washer.
3.
Roll pressure washer out open end of carton.
4.
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle
3.
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Engine oil
Parts bag (which includes items listed below)
Owner's manual
Registration card
Handle attachment hardware
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer hetpline at 1-800-222-3136.
4.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1.
Attach handle to main unit.
2.
Add oil to engine crankcase.
3.
Add fuel to fuel tank.
4.
Connect high pressure hose to spray gun and
pump.
5.
Connect water supply to pump.
Attach
Handle
1.
Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Ahgn Holes _,_,._.._sHuap_do_s _
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2.
Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
Insert one "L" hooks through hole just under billboard
on left side of handle (viewing from rear of unit). Hold
hook in place with pliers and attach Iocknut with
7/16" wrench.
Insert other "L" hooks through hole just above
billboard on right side of handle (viewing from rear
of unit). Hold hook in place with pliers and attach
locknut with 7/16" wrench.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido