Product Safety Information; Product Specifications - Ingersoll Rand 130A1M Especificaciones Del Producto

Product Safety Information

Intended Use:
The model 130 Sand Rammers are designed for use in foundries for compacting sand in bench-
level molds and patterns.
The model 241 Sand Rammers are designed for use in foundries for compacting sand in floor-
level molds and patterns and tamping backfill in construction applications.
For additional information refer to Product Safety Information Manual Form 04581450.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Model Type
130A1M Bench
130A1M-EU Bench
241A1M Floor
241A1M-EU Floor
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16605719 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
03539574_ed5
Piston
Stroke
Blows per
min.
in (mm) † Pressure (L
870 2.5 (63)
870 2.5 (63)
1590 4 (102)
1590 4 (102)
WARNING
Sound Level dB(A)
(ISO15744)
) ‡ Power (L
p
82.2 93.2
82.2 93.2
92.3 103.3
92.3 103.3
6. Thread size
7. Safety Air Fuse
8. Oil
9. Grease - Inject into grease fitting
EN
Vibrations
(ISO28927) m/s
) Level *K
w
38.9 12.8
38.9 12.8
56.2 18.5
56.2 18.5
EN-1
2