2Nd And 3Rd Gear Cut-Out Device; Pto; Wheels - GOLDONI FC Serie Manejo Y Cuidado

4.4 2nd and 3rd GEAR CUT-OUT DEVICE

(Only for FC)
When working, if you want to prevent the 2nd or 3rd gear from being engaged
by accident, turn the pin A (fig.3) horizontal. To disengage this cut-out, hold the
gear lever (n.3 fig.1) between 1st and Rev. And turn pin A vertically.

4.5 PTO

The PTO is separate from the gearbox and rotates anticlockwise (depending
on the driving direction).
FC
Engage it with the engine at minimum Rpm. Disengage the clutch (lever n.2
fig.1) and engage the PTO with lever n.4 fig.1.
FC Professional
Engage with engine at minimum Rpm. Disengage the clutch (lever n.6 fig.2 on
left handlebar) and engage the PTO with lever n.9 fig.2.
FC 3+2
Engage with engine at minimum Rpm. Disengage the clutch (lever n.2 fig.1) and
engage the PTO with lever n.7 fig.1.
Lever forward
Lever back
For all models:
PTO Rpm: 923 Rpm with engine at 3600 Rpm; turning direction anticlockwise
(depending on the drive direction)
Profile: 20x17 DIN 5482
If implements that produce a great deal of inertia (e.g. lawn mowers,
brush-wood choppers, etc.) are connected to the PTO, it is advisable to
use a cardan shaft transmission with "free wheel" device. As it prevents
drive from being transmitted from the implement to the machine, this device
allows these latter to immediately stop as soon as the clutch is depressed.

4.6 WHEELS

CAGE WHEELS optional only for FC Professional
With 4.00x8 wheels cage wheels can be mounted.
Mount by placing 4 spacers (one per wheel) between the rubber tyres and the
cages wheels as shown in fig.6.
Cage wheels can also be mounted on 4.10x10 adjustable twin wheels in the
wide version. Mounting is done without spacers as shown in Fig. 11.
= Neutral
= Engaged
41