Canon RS-CL17 Manual De Instalación página 13

8
Hook the Base bracket to the Joint fitting and secure it temporarily
Hook the Base bracket on the protrusion (D) of the Joint fitting, and secure it temporarily using
the four M5 screws (B) attached.
● Pull out the cables.
● Firmly tighten the screws (B) after adjusting the projection angle as explained in page 13.
B
9
Put the cables in to the pipe and
attach the covers
When using thicker cables, make a hole
aside from those for ceiling-mount bracket,
and insert the cables into the new hole.
1 Pull the cables out of the cable hole in
the ceiling.
2 Put the cables inside the pipe.
3 Close the inner cover of the pipe and
then close outer cover of the pipe.
Secure to the extension pipe using the
supplied M3 screw.
4 Connect the cables to the projector.
D
B
11