How To Use Accessory Tray; Low Pressure; High Pressure; How To Use Spray Tips - Craftsman 580.752870 Manual Del Operador

Ocultar thumbs Ver también para 580.752870:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension, high pressure hose
and quick connect spray tips.
1.
Place spray gun in wide groove on accessory tray as
shown. Pull rubber strap tight around spray gun and
place hole in strap over tab on accessory tray.
2.
Place nozzle extension in narrow groove on accessory
tray. Pull rubber strap tight around nozzle extension and
place hole in strap over tab on accessory tray.
3.
Insert multi–colored spray tips in holes provided on
front of accessory tray.
4.
Place one end of high pressure hose in groove at top
of accessory tray and wrap high pressure hose around
hooks as shown.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger is locked. The spray tips vary the spray
pattern as shown.
Follow these instructions to change spray tips:
1.
Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
accessory tray.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER change spray patterns without the trigger locked on the
spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:

High Pressure

40° White
2100 PSI
2.3 GPM
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
Usage Tips
• For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
• Do Not get closer than 6 inches (15 cm) when cleaning
tires.
14

Low Pressure

Black
Use to apply
detergent
15° Yellow
0° Red
2300 PSI
2700 PSI
2.2 GPM
2.1 GPM

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido