Configuration - Victron energy VER Manual De Instrucciones

2.4 Configuration

For initial configuration, it is recommended to configure the device with the configuration software, VGR Configure. This
software can be downloaded from our website.
1. Download, install and start the VGR Configure on your PC.
2. Connect the Ethernet Remote to your pc with supplied USB cable.
3. Open the first configuration screen, 'Change general settings'.
4. Select the connected type of device in 'Monitored device'.
5. Synchronize the Ethernet Remote clock with the PC Clock by pressing the corresponding button.
6. To apply the new values press Save button and wait until the Ethernet Remote comes up again after programming
the new values.
7. Select Change network settings menu and in Ethernet tab configure/check the IP settings. Ask your network
administrator for the correct configuration (if you plan using VER in standalone mode see Tip in 3.1).
8. Configure/check the SNMP settings in corresponding tab (if needed). See 3.2 for more details.
9. Select Web interface tab if you prefer to change the default values of HTTP credentials. See 3.1 for more details.
10. To apply the new values press the Save button and wait until VER comes up again after programming the new
values.
4