Additional Safety Instructions; Machine Information; Technical Specifications - VONROC DS502AC Traducción Del Manual Original

b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.

ADDITIONAL SAFETY INSTRUCTIONS

• Do not use oversized sanding sheets, but follow
the manufacturer's specifications for the size of
sanding sheets. Sanding sheets which project
over the sanding pad may cause injuries as well
as block and rip the sanding sheets or cause a
kickback.
• It is not recommended to sand lead paint. Lead
paint should be removed by a specialist only.
• Do not work on materials which release hazar-
dous substances (e.g. asbestos). Take precauti-
ons if hazardous, combustible or explosive dust
is likely to occur. Wear protective dust mask.
Use dust extraction system.
• If plaster board or plaster is sanded, this may
cause static electricity to build up on the tool.
To ensure your safety, the wall sander is
earthed. Remove dust with an earthed dust
extractor only.
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Do not use the machine for sanding magnesium
workpieces.
• Wear safety goggles. Wear hearing protection.
If necessary, use other protective means, such
as safety gloves, safety shoes, etc.
• Hold the machine by the insulated gripping
surfaces where the accessory may contact hid-
den wiring or the mains cable. If the accessory
contacts a ‚live' wire, the exposed metal parts
of the machine can also become ‚live'. Risk of
electric shock.
• Be very careful when sanding painted surfaces.
• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly sup-
ported or fixed.
• Only use sanding paper that is suitable for use
with the machine.
• Only use sanding paper with the correct
dimensions. Make sure that the sanding paper
is properly mounted.
• Inspect the sanding paper before each use.
Do not use sanding paper that is worn because
of prolonged use.
• Never put the machine down on a table or a
workbench before it has been switched off.
WWW.VONROC.COM
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a mini-
mum thickness of 1.5 mm2. If you use an exten-
sion cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
The machine is designed for sanding walls and
ceilings, for sanding smoothed drywalls, for remo-
ving paint, wallpaper and adhesive remnants. It is
not permitted to use cutting-off wheels, roughing
wheels, fan-like grinding wheels or wire brushes. The
machine is not suitable for processing objects con-
taining asbestos. Improper use may damage the tool.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No-load speed
Disc diameter
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
EN
DS502AC
220-240V ~
50/60 Hz
1050W
600-2600/min
Ø 215 mm
5.04 kg
93+3 dB(A)
104+3 dB(A)
4.16+1.5 m/s
2
7