Replacing Belt; Replacing Headlight - Triple S AF9 Instrucciones De Operación

38
The headlight
What to buy
This cleaner uses a 12 volt, wedge
base type 912 bulb, part no.
27313-101.
How to replace
Disconnect cleaner from electrical
outlet.
38
Using a screwdriver, remove
the two screws as shown and lift off
lens.
The belt
The belt on your cleaner causes the
agitator to rotate and is important for
the effective operation of the cleaner.
The belt is located under the bottom
plate of the cleaner and should be
checked from time to time to be sure it
is in good condition.
When to replace
To check belt, remove bottom plate
and hood as shown in "How to
replace belt." Replace belt if it is
stretched, cut or broken.
What to buy
To assure effective operation, use
only genuine Triple S belts with your
cleaner. When purchasing a new
belt, ask for part no.
38528-033.
39
Pull old bulb straight out of
39
socket. Push new bulb straight
into socket until locked into place.
Excessive force is not required.
41
How to replace
Disconnect cleaner from electrical
outlet.
Place handle in low position and
turn cleaner over so bottom side is
up.
Remove the 4 screws as shown
41
with a Phillips head screw driver.
Lift off bottom plate (A).
40
Reposition the lens and secure
40
with the two screws.
42
A
Remove agitator and used belt.
42
Discard used belt.
Continued
9