LaTrax Alias Guia De Inicio Rapido página 2

5. ARM YOUR HELICOPTER FOR FLIGHT
Place the model on a level surface with the blue LED facing
you (nose out). Move the throttle stick to the full down position
(throttle off). The helicopter will not arm unless the throttle
stick is in the down position (A). Push in and release the
throttle stick to arm your model for flight. The transmitter will
emit a fast-rising double tone indicating that the helicopter is
armed and ready to fly (B). Note: When the throttle stick is
left idle for 5 seconds or the helicopter detects an impact,
the helicopter will automatically disarm.
6. FLY YOUR HELICOPTER
Gently push the throttle stick forward until the model begins to lift off. Reduce throttle to maintain a hover when the
model is at least 3 feet (1 meter) off the ground. This height will keep the model away from ground turbulence for
more stable flight. Use gradual inputs until you become familiar with the controls.
• Gain Altitude
• Reduce Altitude
Throttle Stick
Push in and release to arm/disarm
Gain Altitude
Rotate
Left
Reduce Altitude
Rudder Trim
(Rotation)
Power Switch
Transmitter Battery
Charge Level
AUX1 Status Indicator
Helicopter Lights Status
Rudder Trim Indicator
(Rotation)
Battery Charge Level Indicators
The helicopter has 2-way communication with the transmitter and will alert you when the battery level is low. When the battery is nearly
discharged (approximately 30 seconds before low voltage cutoff), the transmitter will emit a tone every 5 seconds. During this time, fly
the helicopter to a safe location and land it. In the last 5 seconds, the transmitter will emit the tone continuously. WARNING: To prevent
permanent damage to your battery pack, ALWAYS disconnect the battery whenever the helicopter is not in use.
2
©2014 LaTrax. No part of this manual may be reproduced or distributed in print or electronic media without the express written permission of LaTrax. The product may vary from the images contained within.
• Rotate Left
• Fly Sideways
Left
AUX1 Button
Default Setting:
Initiate Trick Sequence
(Fast Mode only)
Rotate
Right
LCD Screen
Mode Indicator
A.
Throttle off Push in and release
• Fly Forward
• Fly Backward
AUX2 Button
Push in and release to change flight mode
Default Setting:
Lights On/Off
Fly
Sideways
Left
B.
Disarmed Screen
Armed Screen
• Rotate Right
• Fly Sideways
Right
Flight Stick
Fly Forward
Sideways
Right
Fly Backward
Elevator Trim
(Forward Flight)
Aileron Trim
(Sideways Flight)
Helicopter (Receiver)
Battery Charge Level
AUX2 Status Indicator
Elevator Trim Indicator
(Forward Flight)
Aileron Trim Indicator
(Sideways Flight)
Fly