Sanus VMF518 Manual De Instrucciones página 13

4. Place the wall plate template
template and tape in place.
12
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the two pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 3 in. (75 mm).
6. Partially install the TOP lag bolt
NOTE: This space allows you to remove the wall plate template
4
at your desired height and position the slotted holes over your stud center line. Level the wall plate
12
, leaving about 1/2 in. (13 mm) space from the wall.
15
5
14
12
and hang the arm assembly/wall plate
12
3 in. (75 mm)
7/32 in.
(5.5 mm)
12
onto the top lag bolt
13
6
≈ 1/2 in.
(13 mm)
15
12
.
15
13