Descargar Imprimir esta página

Bio Green THERMO 2 Instrucciones De Instalación Y Funcionamiento página 5

Termostato digital

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Installation
Make sure that the mains voltage corresponds to the voltage indicated in Chapter 2
(technical data). The place of installation must be chosen so that the unit can under no c-ir
cumstances get wet (e.g. dripping condensation, open roof hatches, etc.) or fall into water.
The thermostat may be operated in a
horizontal or vertical position.
1.
Connect the heating or cooling
unit to the thermostat.
so, insert the plug of the corres-
ponding heating or cooling unit
in the socket on the thermostat.
2.
Now connect the connecting
cable of the thermostat to a
110VAC mains socket.
3.
Position the end of the sensor
cable at the most suitable
point for temperature control.
Room temperature control
The sensor should be installed at half room height
and should be freely suspended. The room tempe-
rature can only be optimally controlled when the
sensor is not influenced by draughts, solar radiation
or other heat or cold sources.
Cultivation of plants and seeds
Position the sensor in the soil close to
the roots. The sensor must be entirely surrounded
by soil. In large plant pots the
sensor should be located in the middle of the pot.
Water temperature control
For water temperature control (e.g. in an aquarium), the sensor should be positioned
in the central layers of water. Here too the sensor must be completely surrounded by
water.
To do
5

Publicidad

loading