Descargar Imprimir esta página

Tripp-Lite N035-001 Manual Del Propietário

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

RJ45 Network Signal Splitter
Model: N035-001
Installation
Network Switch
Note: For proper installation, two N035-001s are required.
1. Connect the two RJ45 female ports on one of
the N035-001 units to a network switch using
RJ45 network cable.
2. Connect the RJ45 male connector of the
N035-001 unit to a wall plate or a patch panel.
Warranty and Product Registration
1-Year Limited Warranty
TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of initial purchase. TRIPP LITE's obligation
under this warranty is limited to repairing or replacing (at its sole option) any such defective products. To obtain service under this warranty, you must obtain a Returned
Material Authorization (RMA) number from TRIPP LITE or an authorized TRIPP LITE service center. Products must be returned to TRIPP LITE or an authorized TRIPP LITE
service center with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase.
This warranty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been altered or modified in any way.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT
OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs, such as lost profits or
revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.
Product Registration
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered into a drawing for a chance to win a FREE
Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
FCC Notice, Class B
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications to this equipment not expressly approved by Tripp Lite could void the user's authority to operate this equipment.
WEEE Compliance Information for Tripp Lite Customers and Recyclers (European Union)
Under the Waste Electrical and Electronic Equipment (WEEE) Directive and implementing regulations, when customers buy new electrical and electronic equipment
from Tripp Lite they are entitled to:
• Send old equipment for recycling on a one-for-one, like-for-like basis (this varies depending on the country)
• Send the new equipment back for recycling when this ultimately becomes waste
Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
17-02-207-933693.indd 1
Owner's Manual
N035-001
Copyright © 2017 Tripp Lite. All rights reserved.
PROTECT YOUR INVESTMENT!
Register your product for quicker service and ultimate
peace of mind. You could also win an ISOBAR6ULTRA
surge protector—a $100 value!
www.tripplite.com/warranty
N035-001
Wall Plate
3. Connect the RJ45 male connector of the other
N035-001 unit to the other side of the wall
plate or patch panel.
4. Connect two computers to the RJ45 female
ports on the unit using RJ45 network cable.
PC1
PC2
2/15/2017 4:16:18 PM

Publicidad

loading

Resumen de contenidos para Tripp-Lite N035-001

  • Página 1 2. Connect the RJ45 male connector of the 4. Connect two computers to the RJ45 female N035-001 unit to a wall plate or a patch panel. ports on the unit using RJ45 network cable. Warranty and Product Registration 1-Year Limited Warranty TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of initial purchase.
  • Página 2 N035-001 N035-001 Placa de Pared Nota: Para una instalación apropiada se requieren dos N035-001. 1. Conecte los dos puertos RJ45 hembra en una 3. Conecte el conector RJ45 macho de la otra de las unidades N035-001 a un switch de red unidad N035-001 al otro lado de la placa de usando cable de red RJ45.
  • Página 3 Commutateur de réseau N035-001 N035-001 Plaque murale Remarque : Pour une installation adéquate, deux N035-001 sont requis. 1. Raccorder deux ports femelles RJ45 sur l'un 3. Raccorder le connecteur mâle RJ45 de l'autre des appareils N035-001 à un commutateur appareil N035-001 à l'autre côté de la plaque de réseau en utilisant le câble du réseau...
  • Página 4 Установка Сетевой коммутатор N035-001 N035-001 Пластина для крепления к стене Примечание. Для правильной установки требуются два устройства N035-001. 1. Соедините два гнездовых разъема RJ45 3. Подключите штекерный разъем RJ45 одного из устройств N035-001 с сетевым второго устройства N035-001 с другой...