Storing The Mower - EarthWise 60418 Manual Del Usuario

REPLACING WHEELS
See Figure 16
To Replace a wheel:

Stop the motor and remove the switch key. Remove
battery from the battery compartment.

Turn the mower on its side.

Using a flat blade screwdriver, pry off the hubcap.

Remove the self-locking nut from the wheel axle, then
remove the wheel.

Replace with new wheel and install new self-locking nut
securely.

Replace hubcap.

STORING THE MOWER

See Figure 17

Remove the switch key and store in a secure location out
of the reach of children.

Turn mower on its side and clean grass clippings that
have accumulated on the underside of the mower deck.

Wipe the mower clean with a dry cloth.

Check all nuts, bolts, knobs, screws, fasteners, etc., for
tightness.

Inspect moving parts for damage, breakage and wear.
Have repairs made on any damaged or missing parts.

Store mower indoors in a clean, dry place out of the reach
of children.

Do not store near corrosive materials such as fertilizer or
rock salt.
To lower the handle before storing:

Fully loosen the handle knobs on the sides of the
handle and fold the upper handle down.

Push inward on each side of the lower handle, and
lift the sides of the lower handle past the edges of
the handle mounting brackets.

Fold the lower handle forward, making sure not to
bend or kink the power cord.
WARNING:
USE EXTREME CAUTION WHEN FOLDING
THE HANDLE. THE CORD CAN BE DAMAGED
IF PINCHED BETWEEN HANDLE SECTIONS
CREATING A SAFETY HAZARD.
BATTERY MAINTENANCE
It is recommended to charge the mower every 3 months for
optimum performance when not in use. If the battery has
been in storage for a long time without recharging, it will be in
a low charge state.
MAINTENANCE
HUBCAP
Page 17
SELF-LOCKING
NUT
WHEEL
WHEEL
AXLE
Fig. 16
UPPER
HANDLE
HANDLE
KNOBS
LOWER
HANDLE
Fig. 17