Planet POE-151S Manual De Usuario página 9

With IEEE 802.3af / 802.3at standard; the PLANET PoE
Splitter also can co-work with IEEE 802.3af / 802.3at
End-Span Switch that feeding power over pin 1, 2, and
Note
3, 6.
5.3 PoE Injector and PoE Splitter Installation
For non PoE remote device or Ethernet equipment, the PoE Splitter
and PoE Injector can runs in pair to provide DC Power for those
devices, the table below shows the model of PLANET PoE Injectors:
Model PoE Standard
POE-151 IEEE 802.3af
POE-152 IEEE 802.3af
POE-161 IEEE 802.3at / af
Steps:
1. [Switch & PoE Injector] Connect a standard network UTP cable
from Switch / workstation to "Ethernet" port of PoE Injector and
the PoE Injector get DC power from attached power adapter.
2. [PoE Injector & PoE Splitter]
 Connect the long UTP cable between the port "Ethernet+DC" of
PoE Injector to the port "Ethernet+DC" (or "PoE IN") of PoE
Splitter.
 The PoE LEDs of both Injector and Splitter will light on continu-
ance.
3. [PoE Splitter]
 Connect the UTP cable in the package from "Ethernet" of the
PoE splitter to the RJ-45 port of remote device.
 Adjust proper DC power output and connect proper DC plug from
"DC OUT" of PoE Splitter to the remote device.
Max. PoE Out Power In
15.4 Watts 48V DC
15.4 Watts 48V DC
30 Watts 56V DC
Pass-thru. Speed
10/100Mbps
10/100/1000Mbps
10/100/1000Mbps
1-5