ARDES AR7V01 Folleto De Instrucciones página 7

Operation.
Place the plug in the current socket.
If you wish to seal just one bag, position it in the suction chamber (b), close the appliance and ensure you hear
The "click" of the two side stops.
Press the seal key (2) and the led lights up to indicate the appliance is working.
For a few seconds, suction will start; this is normal, the suction chamber is in vacuum to ensure the upper gasket
(D) presses the bag against the sealing bar (e).
When the led switches of, press the release buttons (g) on the two sides and remove the bag.
If you want to vacuum pack food, place it in a bag, position the opening in the suction chamber (b), close the
Appliance and ensure you hear the "click" of the two side stops.
Press the vac seal key (3). The corresponding led lights up; when it switches off, the process is complete.
Press the release buttons on the two sides and remove the sealed parts.
To stop the appliance from working at any time, press the stop key (1).
To avoid excessive vacuum of delicate food, sealing can be anticipated by pressing the seal key during suction.
Attention: in this case, if the vacuum is too weak, the bag may not seal correctly.
Useful suggestions.
Leave a sufficient length on the opening to seal so it can be easily inserted in the
Vacuum chamber.
Before proceeding, check the opening of the bag is not wet because it may be difficult to seal it hermetically.
The appliance does not completely replace refrigeration or freezing, perishable foods must still be refrigerated
Or frozen.
Keep plastic bags flat, otherwise the seal may be less than optimal.
To avoid creases in the bag during suction, lay it in the suction chamber and keep it pressed until the appliance
Starts to work.
Before sealing fruit and vegetables, leave them to cool for a few minutes.
You are advised to allow at least 40 seconds to pass before sealing.
Problem solving
If the appliance does not work:
Check if the power supply cable is connected to the current socket.
Check if the power supply cable is damaged.
Check if the electric socket works by connecting it to another device.
Ensure the stops are in the locked position.
Check the bag is positioned correctly inside the vacuum chamber.
Wait for the appliance to cool for 40 seconds before re-using it.
Maintenance
GB
Disconnect the plug from the socket and let the appliance cool down well before cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Do not use very wet substances, liquids or cloths to prevent water from entering into the appliance and
irreparably damaging it.
Never use abrasive sponges.
Accurately avoid the substances used for cleaning ending up on the suction tube causing the suction pump to
break.
Avoid use of substances that can damage the gasket on the fixed lower bar.
Avoid use of liquid substances which can detach the resistor protection.
Do not force or pull, during cleaning, the silicone gasket on the mobile upper bar to avoid damaging or removing
it, even partially.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
7