Amano American Sanders CE7 Pro Manual Del Usuario página 10

EN
FIG. 6.1 SANDING PATTERN
The unit is factory set to sanding pattern 2.
1. To alter the sanding pattern to 1:
a.) Loosen the locknuts on A & B.
b.) Turn stem A counter clockwise and stem B clockwise in
1/4 turn increments until the desired pattern is achieved.
c.) Tighten locknuts on A & B.
2. To alter the sanding pattern to 3:
a.) Loosen the locknuts on A & B.
b.) Turn stem A clockwise and stem B counter clockwise until
the desired pattern is achieved.
c.) Tighten locknuts on A & B.
3. To move the pattern to the outer edge of the sanding disc:
a.) Loosen locknuts on A & B.
b.) Turn stem A & B clockwise in 1/4 turn increments until the
desired pattern is achieved.
c.) Tighten locknuts on A & B.
4. To move the pattern away from the edge on the sanding disc:
a.) Loosen locknuts A & B.
b.) Turn stems A & B counter clockwise until the desired
pattern is achieved.
c.) Tighten locknuts on A & B.
FIG. 6.2 RESET CASTER SETTING
1. To reset caster to factory setting:
a.) Loosen the locknuts on A & B (Fig. 6.1).
b.) Rotate stem with large flat blade screw driver to
distance shown.
c.) Tighten locknuts on A & B.
Machine Set-Up
10
A
3
1
2
Figure 6.1
HEIGHT
.772 (19.61)
.872 (21.01)
Figure 6.2
B
MODEL
CE 7
SE7