Listening To Your Ipod - HMDX Audio C20 Manual Del Usario

WARNING:
INSERT AND PIN CONNECTOR ARE DESIGNED FOR
APPLE iPOD MUSIC PLAYERS ONLY. ATTEMPTING TO ATTACH OR
FORCE ANY NON- iPOD MUSIC PLAYER INTO THE ENCLOSED
INSERT OR ONTO THE PIN CONNECTOR WILL DAMAGE AND EVEN
DESTROY YOUR DEVICE.
1. Before you begin, remove your iPod from its
case or 'skin'. Place insert in dock, being
sure that the two plastic tabs face the front of
the unit. Press insert into place, ensuring it is
firmly placed in the dock. Carefully place your
iPod into the docking area so that the pin
connector in the dock is fully connected to
the pin socket on the bottom of your iPod
(Fig. 5).
2. Your iPod will then begin charging, until fully
charged.
NOTE: Your iPod will charge even if the POWER button is turned off. The
unit only needs to be plugged in for the iPod to charge.
3. To remove/replace an insert, first remove your iPod, then place fingernail
in slot on insert (Fig. 3) and gently pull up.
Figure 5
8

Listening to Your iPod

1. Press the POWER BUTTON on the HMDX Audio unit (Fig. 1).
2. Toggle through the AUDIO BUTTON to play the iPod (Fig. 1). The IPOD
ICON will appear on the LCD display on the right side of the clock, to
indicate that the iPod mode has been selected.
Note: When the iPod is docked and in standby mode, it will
automatically begin playing once the iPod mode is selected on the
unit.
3. Press the PLAY/PAUSE button on your iPod to pause play; press play
again to resume play.
4. Turn the VOLUME KNOB (Fig. 1) on the unit to adjust the system volume.
5. Press the or on your iPod to go to the next or previous track.
6. To turn unit off, press the POWER BUTTON. The iPod will continue
charging in the dock.
Listening to a non-docking iPod or other portable
audio devices
If you are using an iPod without a docking port, other MP3 player, or other
portable audio device, you can play it through the HMDX Audio C20 via the
LINE IN located on the back of the unit (Fig. 6).
1. Plug one end of the Connection Cable (included) into the headphone or line-
out jack on your audio device and the other end of the Connection Cable
into the unit LINE IN, located on the back of the unit.
2. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
3. Toggle through the AUDIO BUTTON on the unit until you reach the
auxiliary mode. The AUX ICON (Fig 2) will appear in the right side of the
clock, to indicate that the auxiliary mode has been selected.
4. Turn on and play external audio device.
9