Magic Remote Functions - LG 42UB700T El Manual Del Propietario

MAGIC REMOTE FUNCTIONS

When the message Magic remote battery is low, change the battery . is displayed,
replace the battery. To install batteries, open the battery cover, replace batteries
(1.5 V AA) matching
battery cover. Be sure to point the remote control at the remote control sensor on the TV. To remove
the batteries, perform the installation actions in reverse.
CAUTION
• Do not mix old and new batteries, as this may damage the remote control.
This remote uses infrared light. When in use, it should be pointed in the direction of the TV's remote
sensor.
(For UB800T, UB820T, UB830T Series)
Turns the TV on or off.
Returns to the previous screen.
Press the center of the wheel
button to select a menu. You can
change channels by using the
wheel button.
(EXIT to LIVE)
Switches among broadcast
(antenna) and various inputs.
Color buttons
These access special functions in
some menus.
( : Red,
: Yellow,
Adjusts the volume level.
Displays the Screen Remote.
• Accesses the Universal Control
Menu in some regions.
• Pressing and holding the
button will display a menu to
select an external device that is
connected to the TV.
Used for viewing 3D video.
(For UB830T series)
Mutes all sounds.
Scrolls through the saved
and ends to the label inside the compartment, and close the
(POWER)
(BACK)
Wheel (OK)
: Green,
: Blue)
VOL
(MUTE)
CH
channels.
MAGIC REMOTE FUNCTIONS
(Home)
Accesses the Home menu.
(up/down/left/right)
Press the up, down, left, or right
button to scroll the menu. If you
press buttons while the
pointer is in use, the pointer will
disappear from the screen and
the Magic Remote will operate
like a general remote control. To
display the pointer on the screen
again, shake Magic Remote to the
left and right.
(Voice recognition)
Network connection is required
to use the voice recognition
function.
1. Press the voice recognition
button.
2. Speak when the voice display
window appears on the left of
the TV screen.
• Use the Magic Remote no
further than 10 cm from your
face.
• The voice recognition may fail
when you speak too fast or too
slowly.
• The recognition rate may
vary depending upon the
user's characteristics (voice,
pronunciation, intonation, and
speed) and the environment
(noise and TV volume).
33