Expansion Module for Communication Ethercat ECO4
5 HARDWARE CHARACTERISTICS
The accessory ECO4 has the following hardware characteristics:
1 Ethercat interface with two inputs for RJ45 connectors (it is recommended to use standard
Ethernet cable, CAT 5 and with shield – S/FTP, S/UTP, F/UTP).
The housing of the connectors are internally connected to the equipment ground.
6 CONFIGURATIONS
To configure the serial communication Ethercat, refer to the programming manual and also to
the Ethercat user's manual of the SCA06.
10
SCA06
XA152
Figure 5.1: Shows the accessory ECO4
Status LED
XA151