Innokin iTaste VTR Manual Del Usuario página 7

adjustment of voltage or wattage setting. While the device is on, if you press the function key button the
display screen will show resistance ( Rx.x , for example R2.2 ). Release the function key after 1 second to
display output of the last adjustment of voltage or wattage ( U x.x , for example : U4.5 or P x.x , P8.0 ).
While the iTaste VTR is cycling through is displayed settings you can press function key button to switch
to or from Variable Voltage mod or Variable Wattage mod. Use the Rotational wheel to adjust your
wattage/voltage; clockwise (+) and counterclockwise(-)
Rotational wheel: Rotational wheel for adjustments to the output. The wheel can be rotated clockwise
(+) and counterclockwise(-) to adjust the Voltage and Wattage. Variable Voltage can be adjusted from
3.0 – 6.0 volts in .1 volt increments. Variable Wattage can be adjusted from 3.0 – 15.0 W in .5 watts
increments.
Variable Voltage Mode
When you press the function key, the screen will show you the Ohms first followed by the last
adjustment (The last adjustment may be a voltage or wattage setting), after showing the last adjustment,
the iTaste VTR will enter variable voltage mode by pressing "function key" for 1 second. Voltage can be
adjusted from 3.0 to 6.0 volts in .1 volt increments by moving the rotational wheel clockwise (+) and
counterclockwise(-) .
9/EN-9
Variable Wattage Mode :
When you press the function key, the screen will show Ohms first followed by the last adjustment (The
last adjustment may be a voltage or wattage setting), after showing the last adjustment, the iTaste VTR
will enter variable wattage mode by pressing "function key" for 1 second. Wattage can be adjusted from
3.0 to 15 watts in .5 watt increments by moving the rotational wheel clockwise (+) and counterclock-
wise(-).
Load Ohms Meter :
Press the "Function" button for 2 seconds, the digit screen will display load Ohms if there is any connect-
ed load on this product, the load Ohms range will range from 1.0ohm-9.9ohm. The digit screen will
display "NON" if no load has been detected.
Built-in 3 digit LED display: (Battery Capacity ,Ohms meter, Volts /Watts, Atomizer voltage output).
LED Light Blinking Mode:
The LED light will blink different colors to indicate the current battery voltage.
1/EN-8
10/EN-10