Camera Wiring Diagram - Audiovox Electronics ACA200W Manual De Instalación

Cámara de montaje posterior / patente cableada
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting the Video Signal
1. Connect the included video extension cable to the Yellow RCA jack
on the camera harness.
2. Run the extension cable to the monitor and connect to the Video
input.
Reverse/Normal Image Adjustment
The camera comes standard with a reversed image, designed for mounting
at the rear of the vehicle. If you need to change to a forward or normal
image view, clip the blue jumper wire loop on the wiring cable (labeled
"Mirror Selection" below) to change the camera image to normal. Secure
the clipped wires with electrical tape. To change back to reverse image
view, reconnect the blue wires and secure with electrical tape.
Camera Wiring
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido