Installing The Pedestal - Whirlpool LAB2700MQ3 Instrucciones De Instalación

5. Pull the dryer away from wall so that it can be tipped onto its
back.
6. Protect the floor with a large piece of cardboard cut from the
pedestal carton. Lay the dryer on its back (make sure that the
power supply cord is not under the dryer) so that the
cardboard is under the entire lower back edge of the dryer
(see Figure 1).
7. Go to "Installing the Pedestal" section.
If your washer or dryer is still in its packaging
WARNING
Excessive Weight Hazard
Use two or more people to move washer or dryer.
Failure to do so can result in back or other injury.
1. Position the packaged washer/dryer close to its final position.
Cut the packaging as follows:
Washer: Cut plastic film along dotted cut line around the
base. Do not remove the packaging.
Dryer: Cut carton around top and down corners along dotted
cut lines. Lay all four carton sides on floor. Discard carton top
and corner posts.
IMPORTANT: Leave carton bottom underneath dryer.
A
B
A. Dryer shown
B. Carton sides
2. Lay washer/dryer on its back.
NOTE: When laying the washer on its back, hold the bottom
cap down on the floor. Do not remove the plastic film, corner
posts or top cap. These protect the floor and washer back.
When laying the dryer on its back, the floor and dryer back
are protected by cartoning.

Installing the Pedestal

Follow these instructions to install the pedestal on a washer or dryer.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
1. Open pedestal drawer and remove envelope inside. This
envelope contains 4, #12 x ⁵⁄₈" hex head sheet metal screws
used in step 6.
4
2. Verify that the 4 spacer pads are installed on the top of the
pedestal.
A. Spacer pads
B. Yellow pads
3. Remove the two yellow pads from the front of pedestal and
discard.
4. Remove the Phillips head screw from both drawer slides and
save screws. Remove the drawer from the slides and set
aside. Push the slides back into the pedestal.
5. If your washer/dryer has feet installed, remove them. Do not
install the feet that came with a new washer/dryer.
6. Partially install the two #12 x ⁵⁄₈" hex head sheet metal screws
in the lower holes. Leave a space of about ³⁄₈" (1 cm) between
the screw head and the bottom of the washer/dryer.
A
C
A. Washer bottom
B. Dryer bottom
C. Install screws
A
B
B
C