Konica Minolta PULSOX-300i Manual Del Usuario página 18

Calculation Method for Displayed Values
<Pulse level meter>
The pulse level meter displays the transmitted light amount ratio calculated by
the following equation. The pulse level is indicated in eight levels (0 to 15%, full
scale if over 10%).
Pulse level (%) =
<Oxygen saturation (SpO
Updates the moving average of the oxygen saturation over the last 12 sec-
onds at one-second intervals.
<Pulse rate (P.R.)>
Updates the moving average of the last 8 pulse rates at one-second intervals.
2. PREPARATIONS
Before starting measurements using this instrument, follow the proce-
dure given below to ensure that measurements are stable.
1) Attaching the Wrist Band
Attach the Wrist Band WB-300 (supplied as a standard accessory) to the
instrument. Since the WB-300 is made of elastic material, it allows for
flexibility and comfort of fitting on the wrist.
Procedure
1 Place the instrument with its rear side up.
2 Pass the angled tip of the hook-and-loop tape of the wrist band out-
ward through band fixture A.
When doing so, make sure that the Velcro tape section faces up-
◆
ward.
3 Fold up the inserted hook-and-loop section, and stick it firmly to the
band.
4 Pass the other end of the band outward through band fixture B.
Take care not to twist the band.
◆
5 Fold back and secure the band with the hook-and-loop tape section.
When attaching the instrument to an arm, adjust the band length and
◆
fitting at this hook-and-loop tape section.
E2
Transmitted light amount that varies due to the pulse
Transmitted light amount that does not vary due to the pulse
)>
2
x 100