Publicidad
E L E C T R I C A L
This dishwasher is designed for operation
on an individual 120 VAC, 60 Hz grounded
electrical circuit. Use required fuse (15 amp)
or comparable circuit breaker. Two wire
with ground service to the dishwasher is
recommended for connection at the terminal
box and for grounding.
G R O U N D I N G
This appliance must be connected to a
grounded metal, permanent wiring system;
or an equipment-grounding conductor must
be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on the appliance.
P L U M B I N G
CHECK LOCAL PLUMBING CODES
FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES.
ALL PLUMBING SHOULD BE DONE
IN ACCORDANCE WITH NATIONAL
AND LOCAL CODES.
Built-In Dishwasher
I n s t a l l a t i o n
Leave Installation Instructions and User's Guide with Owner
ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING SHOULD BE
DONE IN ACCORDANCE WITH NATIONAL AND LOCAL CODES BY
QUALIFIED INDIVIDUALS.
R E Q U I R E M E N T S
I N S T R U C T I O N S
R E Q U I R E M E N T S
I n s t r u c t i o n s
WARNING
To prevent accidental contact with electrical connections,
built-in dishwasher models must not be connected to a power
source unless the dishwasher is completely enclosed, with
front panels in place. If the back or either side of the dish-
washer is exposed, a panel must be used to complete this
enclosure. Failure to follow this warning could result in death
or serious injury.
WARNING
To prevent the possibility of electrical shock, this dish-
washer, as other electrical appliances, must be adequate-
ly grounded. It is the responsibility of the installer at the
point of installation, taking into consideration local condi-
tions and requirements. Failure to follow this warning
could result in death or serious injury
WARNING
Disconnect electrical power to dish-
washer before you start! Failure to
follow this warning could result in
death or serious injury.
Publicidad
