Service And Maintenance - Metal Works UCL010 Manual De Instrucciones

®
UCL - NLFRENES - v1.0 - 15102013
EN
Temperature-controlling timing on the LED
1. Set the ultrasonic cleaning time (99 minutes).
2. Press "increase" or "deduce" to set needed cleaning time.
3. Set the temperature (~80°C).
4. Press "increase" or "deduce" to set the temperature of the needed cleaning solution.
5. Press "On/off" key to start the machine to work.

Service and maintenance

This machine is very valuable, so a special man should be assigned to be responsible for operation, service
and maintenance. Thorough checking to the machine should be done periodically.
1. Check the looseness, overheating, dampness and the contact of every connection of the power and the
output line.
2. Check the mesh enclosure of the power cooling fan, and please remove the dust on it.
3. Check the leakage of the sealing of the supporting plate.
4. Please contact the supplier if the ultrasonic oscillator falls off or the power tube is burned.
10