Important Safety Precautions - Sammic XM-12 Manual De Instrucciones

FIGURES DESCRIPTION - PAGE 3
1- Motor block
2- Blender arm
3- Pilot light
4- Adjustment control
5- "On" button
6- Maximum working tilt
7- Maximum depth
8- Blade
9- Lower seal
10- Assembly / Disassembly of the blender arm
USERS MANUAL
This manual describes the installation, operation and maintenance of the
XM-12 blender.
Each machine is identified as follows:
· Name and address of the manufacturer: SAMMIC S.L. C/ Basarte 1 -
20720 Azkoitia Gipuzkoa (SPAIN).
· Machine model and serial number.
· Approval marks.
· The serial number and all information regarding the current legislation
under which this appliance has been manufactured is printed on the
guarantee card and in the declaration of conformity.
NOTE: The 120V models have been approved under the safety standard
UL-763 and hygiene and materials standard ANSI NSF-8.

IMPORTANT SAFETY PRECAUTIONS

In order to reduce the possibility of accidents (short
circuits, injuries or fires, etc.), to get the best perfor-
mances from the machine and to maintain it correctly,
read and follow these instructions attentively. Keep the
instructions and make sure that all users of the machi-
ne read them before using it. Also keep the guarantee
card and the declaration of conformity.
• This appliance has sharpened blades (8). Never
touch the blade when it is moving. Handling should
be limited to cleaning and with the machine unplug-
ged.
• Before using the machine for the first time, and
always with the machine unplugged, clean the area
in contact with food with (lukewarm) soapy water,
rinse and leave to dry.
• Before plugging the appliance in, make sure that the
mains voltage coincides with the voltage indicated on
the name plate attached to the machine. Do not plug
the appliance in if the arm is not inside the container
that you are working with.
• Never operate the machine empty, outside of a con-
tainer. The arm should be submerged up to a maxi-
mum of 2/3 of its length, marked as "MAX" (7). Never
exceed this mark. The maximum working tilt should
be 30° (6).
• The appliance has a pilot light (3) and when said light
is on, this means that it is connected. When the pilot
light is on, handle the appliance carefully, as it will
switch on when the "On" button is pressed (5).
• To avoid splashes, always work with a stable container
and submerge the arm into the container before starting
and do not remove it until it has fully stopped moving.
• Under no circumstances should the appliance be opera-
ted on a surface with an inclination of over 10 degrees
with respect to the horizontal plane. The machine must
always be firmly resting on the surface. The motor shaft
of the machine must always be in a vertical position in
relation to the surface.
• Never place your hand or any other utensil into the
container where the appliance is working in order to
avoid personal or material damage.
• Always disconnect the machine before removing the
blender arm and also before undertaking any clea-
ning, inspection or repair work on the appliance.
• Clean the blender arm after each use as described
below. During each operation, check the status of the
lower seal (9). If you see any signs of deterioration,
contact the authorised repair service.
• Avoid water entering the motor block and, under no
circumstances, submerge it in water. If this occurs,
follow these exact instructions:
- Leave the blender inside the container and do not
touch the container.
- Unplug from the mains.
- Remove the appliance from the container and try to
remove as much liquid as possible from inside it.
- Do not connect the machine again and contact an
authorised technical service.
• Do not use the machine when the cable or plug are
damaged. For repair, contact the authorised techni-
cal service.
• Do not use abrasive detergents (bleach, nitric acid...)
or stainless steel scourers or scrubbers when clea-
ning the machine. They may cause rust or the dete-
rioration of materials.
• Do not allow the appliance to be used as a toy. This
machine is not designed for use by people (including
children of 8 years old and up) with reduced physi-
cal, sensory or mental capabilities or those lacking
the necessary experience or knowledge, unless they
have received supervision or instructions regarding
the use of the appliance from someone responsible
for their safety and understand the risks that this
implies. Do not allow children to play with the applian-
ce. The cleaning and maintenance to be performed
by the user must not be performed by unsupervised
children.
7
- 7 -
Users Manual
EN