Safety Instructions - nedis WIFIWP10GY Guia De Inicio Rapido

Safety instructions

-
WARNING
• Ensure you have fully read and understood the
instructions in this document before you install or
use the product. Keep the packaging and this
document for future reference.
• Only use the product as described in this
document.
• Do not use the product if a part is damaged or
defective. Replace a damaged or defective product
immediately.
• Close supervision is necessary when the product is
used by or near children, animals or infirm persons.
Do not allow children to play with it or touch it.
• Keep the product out of reach from children.
• Battery usage by children should be supervised.
• Only use batteries that correspond with the
specifications.
• Do not use any cell or battery that is not designed
for use with the product.
• Remove the battery before the product is
scrapped.
• This product may only be serviced by a qualified
technician for maintenance to reduce the risk of
electric shock.
Installing the Nedis SmartLife app
1. Download the Nedis Smartlife app for Android or
iOS on your phone via Google Play or the Apple
App Store.
2. Open the Nedis Smartlife app on your phone.
3. Create an account with your e-mail address and
tap Continue.
You will receive a verification code on your e-mail
address.
4. Enter the received verification code.
5. Create a password and tap Done.
6. Tap Add Home to create a SmartLife Home.
7. Set your location, choose the rooms you want to
connect with and tap Done.
Adding the product to the Nedis
SmartLife app
Plugging the micro USB cable A
4
to connect the product to a Wi-Fi network.
1. Plug A into the micro USB charging port A
i
2. Plug the other end of A
; 1.0 A USB power supply.
is required
i
5
i into a suitable 5.0 VDC
-
Do not use a USB power supply with a higher
voltage.
The Wi-Fi indicator LED A
to indicate the product is ready for pairing.
3. Press and hold the Wi-Fi button A
the Wi-Fi pairing.
A
3 blinks every 1.5 seconds to indicate the product
is searching for a Wi-Fi network.
4. Tap + in the Nedis SmartLife app.
5. Select the device type you want to add from the
list.
6. Follow the instructions in the Nedis SmartLife
app.
Make sure you connect the product to a 2.4 GHz
4
Wi-Fi network.
7. Rename the product after it has been found and
added.
8. After confirming you can control the product with
your smartphone.
To connect your SmartLife account to Amazon Alexa
and/or Google Home, set it up using the "Smart Life"
action or skill. For more details check the instruction
on either Amazon or Google.
Placing the batteries (optional)
The product works either on batteries or with a
micro USB cable and power adapter.
-
Disconnect the product from the power source
before placing or removing batteries.
-
Use only size AAA batteries (not included) for
this product.
1. Open the battery compartment A
2. Place 4 batteries into A
-
Make sure to match the (+) and (-) polarity
markings.
3. Close A
6 .
- Make sure A
no water can run into A
A blinks 0.5 second on and 3 seconds off to
3
indicate the batteries are connected.
Installing the product (image C)
1. Position the product and a water reservoir. Choose
between:
Option A:
. Place the product on a flat, stable surface.
Place a water reservoir close to the product.
5
3 blinks every 0.5 second
to activate
4
6 .
6 .
6 is completely closed to ensure
6 .