To the side walls
DACOR_DW9500M_DD68-00197A-01_EN.indd 23
1. Put a large towel on the bottom of
2. To prevent damage to the drain hose
3⁄16" (5 mm)
Skip this process if you have performed it
in Step 2 above.
3. Remove the side spacer caps with a
4. Drill one hole into both sides of the
• Make sure the hole you drill is smaller
• Make sure the drill bit does not strike
5. Tighten the provided screws into the
the dishwasher (covering the sump) to
prevent wood shavings or screws from
falling into the dishwasher sump.
through the water supply line, slightly
pull out the dishwasher and bend the
built-in ear brackets of the left and
right housings by 3⁄16" (5 mm). When
done, reinsert the dishwasher with its
center aligned.
NOTE
flat-head screwdriver.
kitchen cabinet, totaling 2 screw holes.
than the diameter of the screw.
the sides of the spacer cap holes.
holes to secure the dishwasher to the
cabinet.
English 23
2017-08-23
8:54:56