Depth Units - Whites MX 7 Manual Del Propietário

When Tone Identification is in single tone, all accepted metal types produce
the same audio pitch during searching. If the Discrimination is set to reject a
specific target range, that range may not produce a beep of any pitch. Reject-
ed targets often do not produce any tone (silence).
To Adjust Tone Identification:
1. Press Options and use up or down arrows to select Tone ID.
2. Press + & - to select the type of Tone Identification desired.
3. Press Options to exit or wait 10–15 seconds for the options mode to
automatically time out.
Tone ID Settings
1-Tone
• All targets produce the same pitch beep (no tone ID).
2-Tone
• Iron targets produce a low-pitched beep; all other targets produce a high-
er pitched beep.
4-Tone:
• Iron (lowest)
• Foil & Pull Tabs
• Nickels
• Coins (highest pitch)
8-Tone:
• Large Iron (lowest)
• Small Iron
• Foil/ Small Gold
• Nickels
• Pulltab
• Screwcap
• Zinc/Indian Head Penny
• Dime – Dollar (highest pitch)
20-Tone:
• Each of the 20 Display ID segments (discrimination zones) produce their
own uniquely-pitched beep, starting with iron (the lowest pitch) to Silver
Dollars (highest pitched).

Depth Units

The MX 7 can report target depth in inches or metric.
1. Press Options and use Up & Down arrows to select INCHES/METRIC
2. Press + or - to select the units of measure desired.
3. Press Options to exit or wait 10–15 seconds to automatically time out.
20