Installation Instructions - Gabarron PHM Serie Instrucciones De Instalación Y Guía Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. IMPORTANT INFORMATION
• The warranty of the panel heater will not cover any damage
caused by non observance of any of these instructions.
• This Guide must be kept and given to any new owner.
• Before connecting this appliance to any power supply, the
wall fixing bracket located below has to be detached.
• Check that the voltage shown on the rating plate on the
heater is the same as the voltage of the supply to which
connection is to be made.
• Should the heater be moved and reinstalled it is essential that
the work is carried out by a competent electrician.
• The use of panel heaters is forbidden in any area where there
is a presence of gases, explosives or inflammable objects.
• Do not use this heater to dry clothes.
• Neither the connecting cable nor any other object must come
into contact with the hot unit.
• Do not cover this heater at any time.
• The surfaces of this heater can be hot, so young children
should not be left unsupervised in the vicinity of the heater.
• The air outlet grill at the top of the heater cabinet and the air
inlet at the bottom of the heater are provided to ensure the
most efficient operation of the appliance. They also protect
the heater from overheating; therefore, it is essential that at
no time are they covered.
• This heater should be disconnected from the electricity
supply before any repair work is carried out. This action
should also be taken during the times of the year when heat
is not required.
• The panel heater should not be installed just below an
electrical socket.
• The appliance must be installed in such a way that switches
and other control devices cannot be touched by a person
using a bath or shower.
• The installation must be carried out in accordance with the
current electrical regulations.
• The heater is fitted with a flexible cable size 3 x 1.00 mm2
for electrical connection. It may be used to connect the
heater to the fixed wiring of the premised through a
suitable connection box positioned adjacent to the panel
heater.
• This appliance must be connected to the supply by fixed
wiring. The supply circuit to the heater must incorporate a
double pole isolating switch having a contact separation of
at least 3 mm.
• If the flexible power cable for this unit is damaged, it may
only be replaced by a repair workshop recognised by the
manufacturer, as special tools are necessary.
• This appliance must be earthed.
• Before carrying out any work inside the appliance, the panel
heater must be disconnected from the electricity supply.
• The presence in the air of particles of smoke, dust and other
pollutants could, in time, discolour the walls and surfaces
around the panel heater.
• Please complete the enclosed warranty card and return it to
the manufacturer to enable registration to take place.
• All models are supplied with an electrical interrupt cut-out.
This will switch off the heater if, for any reason, it overheats.
Should the cut-out operate, turn the heater off and remove
the cause of the overheating. The cut-out will be reset
automatically.

2. INSTALLATION INSTRUCTIONS

When positioning the heater for installation it is important
that a minimum clearance of 50 cm must be allowed between
the heater and any combustible materials, such as furniture,
curtains etc, to ensure the best heating results.
Open the carton at the indicated side. The screws are in the
accessories bag. Turn the carton upside down to allow the
heater to stand. Check that it is the correct model and that it
is in good condition.
Fix the two square brackets to the back of the heater by using
the two small screws (see Fig.1).
8cm
10cm
min 15cm
Position and fix the top bracket at the correct distance from
the floor (see Fig. 2) and hang the unit on the hooks of the
top bracket. Mark the fixing points on the wall using a pencil.
Use the heater fixing holes as a template and mark the wall
through the two fixing holes in the square brackets. Fix the
heater to the wall.
4
Fig. 1
41.0 cm ( 750W)
56.0 cm (1250W)
63.5 cm (1500W)
78.5 cm (2000W)
8
9
7
10
6
5
4
*
3
2
Fig. 2
min 15cm

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Phm075tPhm125tPhm150tPhm200tPhm075Phm125 ... Mostrar todo

Tabla de contenido