Electrical Requirements; Grounding Instructions; Prepare Microwave Oven; Prepare Cutout/Cabinet Opening - KENMORE ELITE 405.22273310 Instrucciones De Instalación

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.

GROUNDING INSTRUCTIONS

For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS

Prepare Microwave Oven

1.
Unplug microwave oven before proceeding with installation.
2.
Remove any loose items inside microwave oven.
3.
Gently turn microwave oven onto its top, with the door facing
forward (toward installer).
4.
Align the #33 holes on the microwave oven bottom with the
#33 holes on the rails, as shown, making sure the flanges are
forward and pointing up.
A
A. Rails (2)
B. Microwave oven bottom
C. Short screws (4)
5.
Secure the rails to the microwave oven bottom using four
short screws through the #33 hole sets.

Prepare Cutout/Cabinet Opening

1.
On the cutout floor, find and mark the centerline.
2.
Place the bottom duct in the opening, with the flange resting
against the bottom front facing of the opening.
A
D
A. Cutout floor
B. Centerline
C. Bottom duct
EN-3
B C
D
D. Flanges
E. Door
B
E
D. Bottom duct flange
E. Front facing
E
C