Chauvet Q-SPOT 460-LED Guía De Referencia Rápida página 4

Q-Spot 460 LED QRG
Gobo
Replacement
1. Turn the product off and disconnect from power.
2. Unlock the gobo cover and slide it away.
3. Separate the gobo plate away from the gobo wheel by pushing it toward
the front of the moving head (direction 1 in the diagram). Be careful not
to push the gobo out of the gobo plate.
4. Extract the gobo plate by pulling it outward (direction 2 in the
diagram).
5. On a flat surface, remove the expansion ring that holds the gobo in
place and remove the gobo from the gobo plate.
6. Insert a new gobo and hold it in place with the expansion ring.
7. Slide the tip of the gobo plate under the pressure plate near the center of
the gobo wheel.
8. Push the gobo plate inwards. DO NOT force the gobo plate into the
gobo wheel slot. If correctly installed, the gobo plate should easily snap
itself into the gobo wheel slot.
4
EN