Technical Specifications; Operating Range; Before Operation - BEAL ESSENTIEL-SAE2600 Manual De Utilización

Technical Specifications

Rated voltage
Rated frequency
Rated power consumption
Rotation
Max. blowing speed
Max. air volume
Bag volume
Weight without cable
Protection class II
The A-rated sound pressure level of the device measured in accordance with DIN 45635 Part1, Appendix D is:
Working-place-related emission value L
Vibration:
These values were measured in accordance with the following standards: EN 60 335-1/A1:2004; EN 60 335-2-100:2002
This device has a radio interference suppression according to: EN 55014-1, EN 55014-2
Please wear ear protectors!
Noise emission information in accordance with the German Equipment and Product Safety Act (GPSG) and the EC
Machine Directive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator
will require noise protection (e.g. wearing of ear protectors).

OPERATING RANGE

This Blower/Vacuum device must only be used to blow
away or vacuum dry and light materials as e.g. dry
leaves, small branches, and pieces of paper. The vacu-
uming of heavy materials as e.g. metal, stones, big
branches and broken glass is expressively excluded.

BEFORE OPERATION

Unpacking
1. Take all parts out of the packaging.
2. Check all parts for transportation damages. If you
detect any damages or if parts are missing, please
contact your dealer.
Assembly
Attention ! Always pull the plug and switch the
device OFF, before you assemble the device or
replace parts.
Blowing
1. Align the grooves on the blower tube with the grooves
on the blower outlet. Push the blower tube onto the
blower outlet until it locates in the right position (Fig. A).
2. Fix the adjustable shoulder harness on the top han-
dle, put the blower on (Fig. B).
ESSENTIEL-SAE2600
V~ 230-240
Hz 50
W 2600
rpm 15.000 - 18.000
km/h 270
3
m / min. 7,5
l 45
kg 4,7
: 85 dB(A)
pA
4,13 m/s
3. Assembly the power cord according to the picture
Operating instruction
1. Get though the power, move the power off/on switch
2. Adjust speed control and the speed is moderate
3. Direct the blow tube toward the leaves (Fig. F)
Vacuum mode
1. Press the button of the blower tube downward, draw
2. Clear the tube outlet by using the brush to protect the
3. Align the blower tube lower with the grooves on the
4. Unload the Impeller Guard (Fig. K)
5. Align the blower tube with the mark "Δ", insert the
6. Put the bag hook on the cable cleat of blower tube,
GB-3
[K 3,0 dB(A)]
2 2
[K 1,5 m/s ]
C1,C2
to the ON position (Fig. D)
(Fig. E)
the tube out of housing (Fig. G)
tube being blocked when suck the leaves (Fig. H)
blower tube upper. Push the blower tube lower onto
the blower tube upper until it locates in the right posi-
tion (Fig. J)
blower tube to the housing, and revolve the blower
tube about 90 degree according to the fig. L2, the
hook should be locked according to the pic. L3
and insert the bag to the housing (Fig. M)