Tabla de contenido
Publicidad
Finisher Start-Up
Inbetriebnahme des Finisher • Démarrage du Finisher • Puesta en marcha del Finisher •
Avvio del Finisher
Perform these steps before
dry-finishing
1
Switch
POWER
ON.
2
Verify TEMP CONTROL setpoint between 70 °C and 75 °C (158 °F and 167 °F) on the
TEMP CONTROL
panel. (See p.
3
Verify HI LIMIT setpoint between 80 °C and 89 °C (176 °F and 192 °F) on the
panel. (See p.
41
for instructions.) Factory setting of 85 °C recommended.
4
Verify that exhaust damper on the rear of the Finisher is fully open. (See p.
(see p. 23) or
dip-finishing
35
for instructions.) Factory setting of 70 °C recommended.
(see p. 29).
HI LIMIT
control
11.)
POWER
switch
Netz-Schalter
Interrupteur de mise sous tension
Interruptor de suministro eléctrico
Interruttore di alimentazione
Ström-brytare
Strøm-kontakt
85 °C
70 °C
Virtakytkin
HI LIMIT
TEMP CONTROL
19
T
Publicidad
Tabla de contenido
