TRENDnet TPE-80WS Guía De Instalación Rápida página 8

Q4: My 802.3af Powered device does not power on when I plug the device into
the Switch. What should I do?
A4:
First, verify that your PoE device supports IEEE 802.3af protocol. Second,
verify that your PoE device powers up using its power adapter. Third, power cycle
the PoE switch. Unplug power to the switch, wait 15 seconds, then plug the
power back in. Fourth, plug the device into a different port on the PoE switch.
Fifth, try using another Cat-5e cable.
Q5: I forgot the administration password. How do I reset my TPE-80WS?
A5:
Press on the default button using a pen or paperclip for 10 seconds. The
default password is admin.
Q6: What are the default port settings for configuring the Switch through the
console port using HyperTerminal?
A6:
Bits per Second: 115200; Data bits: 8; Parity: None; Stop bits: 1; Flow control:
None; Emulation: VT100.
If you still encounter problems or have any questions regarding the TPE-80WS, please
contact TRENDnet's Technical Support Department.
6