Quick Setup - Alto SXA18P Guia De Inicio Rapido

QUICKSTART GUIDE (ENGLISH)
BOX CONTENTS
SXA18P
Quickstart Guide
Safety & Warranty Information Booklet

QUICK SETUP

Make sure all items listed in the BOX CONTENTS section are included in the box.
1.
READ SAFETY & WARRANTY INFORMATION BOOKLET BEFORE USING THE PRODUCT.
2.
Study the connection diagram in this guide.
3.
Place all devices in an appropriate position for operation.
4.
Make sure all devices are turned off and all faders and gain knobs are set to "zero."
5.
Connect all sound sources' outputs to amplifier inputs as indicated in the diagram.
6.
Connect the amplifier outputs to speakers.
7.
Plug all devices into an appropriate power source.
8.
Switch everything on in the following order:
9.
•
Sound sources (i.e. microphones, turntables, CD players, etc.)
•
Mixer
•
Amplifier
•
Speakers
When turning powering down, turn everything off in the following order:
10.
•
Speakers
•
Amplifier
•
Mixer
•
Sound sources
REAR PANEL DIAGRAM
Direct/Passive Switch- Sets the operating mode of the speakers. Refer to the
1.
chart on the Specifications page for more details on how this affects the signal
routing
Input connector- Connect your Speakon* cable to this input
2.
Thru/Output connector- Connect your Speakon cable to this output
3.
LINE ARRAY HARDWARE PARTS
FB-1
SAT-HD-L SAT-HD-R
* Speakon is a trademark of Neutrik® AG, registered in the U.S. and other countries.
SUB-HD-L
SUB-HD-R
SH
3
1
2
3