Product Specifications; Installation Procedures - Winplus LM55970 Instrucciones De Cuidado Y Uso

Product Specifications:

1. Operating Voltage: 120Vac, 60 Hz
2. Wattage: 48 W / Stand-by mode: 1 W MAX
3. Light Output: 3800 lm
4. Colour Temperature: 4000K
5. LED Life Cycles: up to 50,000 hrs
6. Dimensions: 116 cm / 45.6 in (L) x 12.6 cm / 4.9 in (W)
x 8.5 cm / 3.3 in (H)
7. Weight: 2.4 kg / 5.2 lb
8. Waterproof rating: IP 65
9. Operating temperature: -20°C to 40°C / -4°F to 104°F

Installation Procedures:

The product is intended to be connected to a plug and does not need to be switched
on/off as it is controlled by the motion sensor. You do not need to disconnect from plug
except for changing Smart Sensor Control setting. The default settings for the Smart
Sensor Control can be found on page 8.
For covered patio, covered backyard, covered boat dock, etc. installation, please use
flush mount only.
Due to the sensor's ability to detect movement through walls and doors, it is recom-
mended to disable the motion sensor (see P.12) when installing the light in small rooms
(e.g. storage closet, pantry, etc.) so movement outside these rooms cannot be picked up
by the sensor. The light will operate through the Main switch in this scenario.
NOTE: The sensor can detect movement through walls and doors.
Ceiling hanging with chains:
Final installed illustration
4
This product is ETL/cETL Listed
1
1. Select a suitable mounting location, and
make sure the wooden surface is suitable
for supporting the lighting fixture. Use
the measuring template to mark the hook
locations on the mounting surface.