Dip Switch Settings - Steren CCTV-255 Manual De Instrucciones

DIP switch settings

To set the DIPs is necessary to remove the mounting bracket of the camera,
follow these steps:
- Turn left support for withdrawal.
- Remove the label located at the base of the camera.
SWITCHES 1 TO 6
By using these switches you can set the direction of each of the cameras
by binary code. When the switch is in the off position, represents a zero and
when it is on position represents a 1.
Thus, for example, to set the 52 position you must set the switches 3, 5 and 6
in the ON position and set the camera 25 should turn on switches 1, 4 and 5.
15