Korenix JETPoE JetNet 5710G Guía De Instalación Rápida página 3

Wall mounting the Unit
JetNet 5710G supports wall-mounting only. There are 6 screw holes on the rear side of the
JetNet 5710G for fixing the mounting plate. Use the screws from the package to lock the
plates as shown in the Figure-A and Figure-B.
Use appropriate screw with 4.2mm nut to lock the device on wall or panel where with good
heat dissipation.
Grounding JetNet 5710G
There is one grounding screw on the right side of JetNet
5710G. Connect the frame grounding of JetNet 5710G
to the grounding surface to ensure safety and prevent
noise for communication interference.
Chassis Earth Ground