Setting The Working Pressure; Filter Unit; Draining Condensate Using The Drain Valve - Parkside PDWE 8 B2 Traducción Del Manual De Instrucciones Original

♦ Before using the compressed air maintenance
unit, check the direction of the compressed air
flow using the "▸" mark on the surface . Incorrect
installation will not generate sufficient pressure .

Setting the working pressure

After connecting the compressed air maintenance
unit to a compressed air source, you can adjust the
desired operating pressure by using the air pres-
sure regulator .
♦ First release the locking device by pulling the
air pressure regulator
♦ Turn anticlockwise to reduce the pressure .
Turn clockwise to increase the pressure .
♦ Read the pressure setting from the compressed
air manometer .
♦ Lock the setting by pushing the air pressure
regulator downward .
NOTE
► Make sure that the maximum possible oper-
ating pressure of the compressed air mainte-
nance unit and the compressed air tool used is
not exceeded .

Filter unit

The filter unit is connected to the air pressure
regulator . The maximum working pressure is
8 bar and the working pressure is adjustable from
0 .5 to 8 bar . The filter unit
condensate and stores the condensate in the
condensate collector
The fill level of the condensate can be inspected
through the transparent viewing window (see fig .
C) . The stored condensate can be discharged via
the drain valve .
■ 36 │ GB │ MT
upwards (see fig . F) .
is used to filter
.
Draining condensate using the
drain valve
Ensure that the compressed air maintenance unit is
mounted horizontally so that the condensate can
also be collected horizontally in the condensate
collector . Do not use the filter unit
condensate collector
NOTE
► Before emptying the condensate collector
make sure the compressed air maintenance
unit has been disconnected from the
compressed air source . Otherwise, the
collected condensate may spray out in an
uncontrolled manner .
► The drain valve
disconnected from the compressed air .
■ In order to drain the stored condensate from the
condensate collector
container .
♦ Press against the drain valve
(see fig . G), it will open and the condensate will
flow into the container .
(fig . G)
if the
is not fitted .
opens as soon as it is
, use an appropriate
from below
PDWE 8 B2
,