Cleaning And Maintenence - MaxPro MPRH1250/32V Manual De Usuario

-the hammer mechanism is activated by applying a slight pressure on the tool when the drill bit is in
contact with the work piece
-best impact drilling results can be obtained by only a slight pressure on the tool needed to keep the
automatic clutch engaged; drilling performance will not improve by applying more pressure on the tool

!select operating mode only when tool is switched off and plug is disconnected
-first set switch 9 as well as switch 8 in position "
-rotate chisel into desired position
-then maintain switch 9 in position "
D
!clean and lightly lubricate the SDS+ adapter before insertion
- pull back locking sleeve and insert adapter in SDS+ chuck while turning and pushing it until it engages;
the adapter locks in position automatically
- pull adapter to check whether it is locked correctly
 g bits!
!clean and lightly lubricate the SDS+ accessory before insertion
- pull back locking sleeve and insert accessory in SDS+ chuck while turning and pushing it until it engages;
the accessory locks in position automatically
- pull accessory to check that it is locked correctly
- remove accessory by pulling back locking sleeve 2
!the SDS+ accessory requires freedom of movement which causes eccentricity when tool is off-load;
however, the accessory automatically centres itself during operation without affecting drilling precision
!only use sharp bits/chisels
!do not use bits/chisels with a damaged shank
^
If the accessory gets jammed, the drive to the spindle is interrupted (causing a rattling noise)
-immediately switch off tool
- remove the jammed accessory
- switch on tool again
-this tool is equipped with carbon brushes which pop up automatically when worn, thus preventing the
motor from being damaged
-when the tool stops unexpectedly, send it to your dealer or the nearest MAXPRO service-station for having the
brushes replaced
,
!while working, always hold the tool at the grey-coloured grip area(s)
-always use auxiliary handle 6 (can be adjusted as illustrated)
- keep the ventilation slots uncovered
- do not apply too much pressure on the tool; let the tool do the work for you
APPLICATION ADVICE
t
- pre-drill a smaller hole, when a large hole is required
- lubricate drill bit occasionally with oil
t ing in a screw at/near the cross cut end or an edge of wood, pre-drill a hole in order to avoid
cracking of the wood
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and the ventilation slots clean.
Clean the tool mount daily.
7
R R otary Hammer MPRH1250/32V User Manual
", but set switch 8 in position "
5

CLEANING AND MAINTENENCE

"
GB
"