Antop PRO-LINE PL-414BG Manual De Instrucciones Para Su Instalación

INSTRUCTIONS
Installation Instruction Manual
Your UFO Amplified HDTV Antenna / PL-414BG can be used as an outdoor antenna for either home or RV. ANTOP's New Generation
Digital Technology allows you the flexibility to set up your antenna in various locations and still receive a great digital reception.
Note: A higher mounting location positioned towards the broadcast tower may result in better reception. Install the antenna as high
as possible, and preferably with a clear path between the antenna and the TV station transmitters. Trees, buildings, mountains, etc.,
can all impact the performance of any antenna. This antenna can also be placed in an attic.
1 / Installation
1.1 For Outdoor Mast Pole Mounting
Attach the bracket to the antenna unit using the screw and wing nut provided.
Attach the antenna to a mast pole by using the clamp kit provided,
preferably on rooftop or side of the house/RV facing the TV station
transmitters.
1.2 For Outdoor Wall Mounting
Fix the antenna onto the wall with screws (screws not provided),
preferably on rooftop or side of the house/RV facing the TV station
transmitters.
1.3 For Attic Use
Note that any structural obstructions will interfere with
antenna effectiveness.
Fix the antenna onto the beam or wall with screws (screws not
provided), preferably on the side of the house facing the
TV station transmitters.
2 / Connecting
2.1 For Outdoor Use, Mast Pole or Wall Mount
Prepping for Connection
2.1.1 Select entry point to house. Drill hole under the eaves at
entry point. Attach coaxial cable (not provided) to connector in
the antenna. For horizontal Wall Mount utilize U-shape coaxial
cable setup to prevent water from entering interior of antenna
casing. With antenna fixed to either a mast pole or an exterior
wall, feed lose end of coaxial cable through drilled opening.
2.2 For Indoor Use, in Attic placement, Prepping for Connection
Select entry point to house. Drill hole at entry point. Attach coaxial cable
(not provided) to connector in the antenna. Fix the antenna onto beam or
wall. Feed lose end of coaxial cable through drilled opening.
2.3 If you haven't already done so, attach coaxial cable
(not provided) to connector in the antenna.
Step 1: Attach the end of coaxial cable to connector on the antenna.
Step 2: Attach the other end of the coaxial cable to the shorter end
(0.3ft) of the power inserter.
Step 3: Attach the long end (3ft) of the power inserter to the ANTEN-
NA/CABLE IN connector on the back of the TV or converter box.
Step 4: Connect the power adapter to the DC socket in power inserter.
PRO-LINE
PL-414BG
Coaxial Cable (not provided)
1
TV Station
Transmitters
The bottom of antenna
4
2
ON/OFF LED
0.3ft
3ft
To coaxial cable To TV
2.3
Back of TV
ANT/IN
CABLE IN
3