Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
5,
Review the unit's assembly to confirm you have performed
all of the following:
6.
I.
Make sure handle is in place and secure.
/
2.
Check that oil has been added to proper level in
/
engine crankcase.
t
3.
Add proper fuel to fuel tank.
4.
Check for properly attached hose connections.
7.
5.
Check to make sure there are no kinks, cuts, or
damageto high pressure hose.
6.
Provide a proper water supply (not to exceed 100°F)
8.
at an adequate flow.
7.
Be sure to read "Safety Rules" and "How To Use
Pressure Washer" before using pressure washer.
Checklist
Before
Starting
Engine
HOW
TO USE PRESSURE
WASHER
If you haveany problems operating your pressure washer,
pleasecatt the pressure washer helpllne at 1-877-224-0458.
How to Start
Engine
The best way to start your pressure washer for the first
time isto follow these instructions step-by-step. This
starting informationalso applies if you have let the it sit idte
for at least a day.
I.
Placepressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no less than 20 PSIat
pressure washer end of garden hose.
2.
Make sure unit is in a level position.
3.
Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure Washer for
Use" for illustrations.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
Squeezetrigger on gun until you havea steady stream
of water. This purges pump of air and impurities.
Attach nozzle extension to spray gun (Figure 5).
Tighten by hand.
Choose spray tip you want to use and insert it into
nozzle extension. See "How to Use SprayTips".
Apply safety latch to spray gun trigger (Figure 6).
Safety Latch
9.
Start engine according to instructions given in engine
owner's manual.
NOTE:
If the recoil starter is hard to pull, squeeze the
spray gun trigger to relieve internal pump pressure.
• Squeezetrigger on spraygun each time recoil starter is
pulledand engine fails to start.
How to Stop Pressure
Washer
• Turn engine off according to instructionsgiven in engine
owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
Publicidad
Tabla de contenido
