Gigahertz Solutions NFA 1000 Manual De Uso página 25

Made in Germany
7.2 User-specific Configuration
of the NFA
This part of the software allows for a customized user definable configuration of the
NFA. The configurations will be stored in the "CONFIG.NFA" file. The new settings
are automatically loaded by the NFA upon its next start when saved on the SD
memory card. To customize your configuration, click the
startup. The following window will appear:
sponding firmware updates) are available on our website. Thank you!
You can use new versions of NFAsoft without installation just by double clicking it.
Notes:
If the high pass is set at 50 Hz, this only refers to the broad band reading or re-
cording. For full information, the frequencies of 16.7 Hz are recorded separately and
can be shown with the help of NFAsoft.
For synchronizing the NFA's time with the computer time please connect the NFA
(with the memory card inserted) to the computer by USB-cable. The synchronisation
is done automatically when you save "CONFIG.NFA" onto the SD memory card. A
manual time setting is not possible at present.
If your recording time does not correspond to the real time, please check whether
your recording time is faster or slower than the real time, and temporarily change
your PC time in the opposite direction. Now synchronise the time setting according
to the descriptions above, and then simply reset your PC time.
NFA1000-5-2-PRELIMINAR_ES.doc- Noviembre 2010
This part of the software is still under development.
Upcoming features:
The LED "< 2kHz" will be adjustable to
a) display of the whole Band or
b) everything except 16.7 Hz and the mains
frequency with or
c) without its 5 even and 5 uneven harmonics
The at present active digital "filter"
which allows to ignore frequency fragments
caused by movements or vibrations can be de-
activated for specific laboratory measurements.
All other features mentioned in the manual.
The latest software revision (as well as corre-
- 24 -
button during NFASoft
© Gigahertz Solutions GmbH