English; Configuration - BeeWi FIAT 500 BBZ253 Guía De Usuario

6
2.3.Pairing
To pair the Bluetooth RC Car with your device, refer to the pairing procedures in your
mobile phone user manual and follow the instructions below:
- Power on the RC Car to turn the unit in pairing mode
- In the iPhone® Bluetooth menu, search for devices, select the device name "BeeWi Red
Fiat500" on the screen and enter the pass key "0000" to add this device into your phone
device list.
3. USING THE CAR
3.1. Connection
If it has been previously paired, the car will automatically
connect to the iPhone® when it is powered on.
If this is not the case, you can also go to the iPhone®
Bluetooth menu and select the "BeeWi Red Mini
Cooper S" device in your device list. Once the status is
"Connected", close the Bluetooth menu and get back to
the main screen.
3.2. Operation
Open the BeeWi Control Pad application
The car will be connected automatically and the control
screen below displayed. By default the control is done
with the orientation sensor and the car is parked (P sign
in red on the top right of the screen).
Press P to exit the park mode and start using the car.
- To move forward, move the iPhone® downwards
- To move backward, move the iPhone® upwards
- To turn left, turn the iPhone® leftwards
- To turn right, turn the iPhone® rightwards
You can also simply use the buttons on the screen to control the car. To do so, you need to
select a different controller as described below.

3.3. Configuration

The configuration menu can be accessed by pressing the
Tools key on the top left. There are 3 different options listed
in the Settings:
- Touch Control: to enable the touch key mode (Motion
Control disabled)
- About BeeWi
4. MAINTENANCE & CAUTIONS
4.1. Maintenance & other hints
- If vehicle does not respond, move closer to the vehicle and try again.
- If the vehicle loses power and moves slower, it may be necessary to replace the batteries
and to check the wheel mechanism for lint, thread, hair or dust.
- To avoid damages, never drive the vehicle on a wet floor, on sand, or in mud, rain or
snow.
- Do not expose the vehicle to extreme temperatures.
- Remove the batteries from the vehicle when storing the product away.
- To protect the vehicle's wheel mechanism from lint, thread, hair, and dust particles, you
can use a small brush, tweezers or tie a small bit of cloth to the tip of a toothpick, etc.,
and wipe off.
- Always keep vehicle clean, use a dampened cloth to wipe off, and then wipe all the
water off with a dry cloth. Never use chemicals to clean the product.
- Avoid holding the wheels when rotating, this will cause the electronic components to short
circuit, overheat and cause malfunction.
- Long period of play time can generate high heat level which causes wear and tear. To
extend product life, it is suggested to allow 10 minutes of cool down period after long
period of operation.
4.2. Cautions
- For a good adhesion, do not use the car on a slippery ground such as tiles or wooden
floor.
- In case of violent shock the car might disconnect. In that case check if batteries did not
fall down and restart it.
- Use good quality batteries delivering enough instantaneous power to avoid any
disconnection.
- Do not shock to vehicle.
- Do not play in thunderstorms.
- Do not touch the wheels when the switch is turned ON.
- Do not leave the vehicle near sources of heat or under direct sunlight for long periods of

ENGLISH

7
ENGLISH