Infosec z2 ex Guia Del Usuario página 10

1 0 . I N D I C A T O R S & A L A R M S
LED
On
Beep 1 time In Every 30
Flash
Beep 1 time In Every 2
Flash
Beep 1 time In Every 0.5
On/Flash
1 1 . T R O U B L E S H O O T I N G
Should the UPS fail to function correctly we recommend you perform the following tests
before calling the Hotline.
Problem
The outlets stop providing
power to equipment. Circuit
breaker button is projecting
from the side of the unit.
The UPS does not
perform expected
runtime.
The UPS will not turn
on.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
10
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 07 19 AA 36 205 08
Alarm
Off
Seconds
Seconds
Overload - Occurs when connected equipment exceeds the
Second
Possible Cause
Circuit breaker has
tripped due to an
overload.
Battery not fully charged.
Battery is slightly worn
out.
The on/off switch is
designed to prevent
damage by rapidly
turning it off and on.
The battery is worn out.
Mechanical problem
Utility Failure - The UPS is providing battery power to
protected UPS outlets.
Utility Failure - The UPS is providing battery power. The
beeps indicate the battery will run out of power shortly.
rating of the unit. Turn the UPS off and unplug at least one
piece of equipment from the UPS.
Turn the UPS off and unplug at least one
piece of equipment. Reset the circuit
breaker by depressing the button, and then
turn the UPS on.
Recharge the battery by leaving the UPS
plugged in.
Contact Hotline.
Turn the UPS off. Wait 10 seconds and
then turn the UPS on.
Contact Hotline.
Contact Hotline.
Condition
Normal
rapid
Solution