Caller Id Solutions; Battery; Photo Frame - GE 27956 Guia Del Usuario

Unit locks up and no communication between the base and cordless handset
• Unplug the power adaptor from the electrical outlet and the bottom of the base.
Remove the handset battery. Wait for 0 seconds and plug the power adaptor
back into the base and electrical outlet. Reconnect the battery and charge for
14 hours.
Searching.... shows in the handset display
• Move the handset closer to the base.
• Make sure the base power cord is connected to a working electrical outlet.
Date/Time setting is restored to default setting
• May be caused by power failure. Set Date/Time again.

Caller ID Solutions

No Display
• Charge the battery (for 14 hours). Or replace the battery.
• Make sure the unit is connected to a non-switched electrical outlet. Disconnect
the power adaptor from the base and reconnect it.
No Caller ID
• You must be subscribed to the standard Name/Number Caller ID service from
your local telephone company to receive CID information.

Battery

If you experience any of the following problems, even after recharging the battery,
you may need to replace the battery pack:
• Short talk time
• Poor sound quality
• Limited range

Photo Frame

Blank area around picture, picture does not fill entire frame:
• This is normal due to the aspect ratio of original picture.
Picture is displaying horizontally:
• You should correct orientation before loading onto photo frame.
Memory card does not fit:
• If using Sony memory stick, you will need an SD adaptor.
• Photo frame does not support Compact Flash cards.
4