Starting And Stopping; Starting Instructions - MTD TROY-BILT TB27BV EC Manual Del Operador

Sopladora/aspiradora manual de 2 tiempos con capacidad para arranque electrico

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

WARNING:

Operate this unit only in a well-ventilated

outdoor area. Carbon monoxide exhaust fumes can be

lethal in a confined area.

WARNING:

Avoid accidentally starting the unit. To avoid

serious injury, the operator and the unit must be in a stable

position when pulling the starter rope (Fig. 13).

WARNING:

When starting the unit, make sure it is not

directed toward people, animals, windows, automobiles or

loose debris.

STARTING INSTRUCTIONS

NOTE: There is no need to turn the unit on. The On/Off switch is in

the On ( I ) position at all times (Fig. 11).

NOTE: This unit includes a cruise control, which allows the operator

to maintain the desired engine speed without having to squeeze

the throttle control.

Before Starting the Unit

1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.

2. Fill the fuel tank. Refer to Fueling the Unit.

Starting the Unit

1. Slowly press and release the primer bulb 10 times (Fig. 12).

2. Move the cruise control to the LO (slow) position (Fig. 11).

NOTE: Keep the cruise control in the LO (slow) position and

DO NOT squeeze the throttle control (Fig. 11) until step 7.

3. Flip the choke lever clockwise until it clicks into the START

position (Fig. 12).

4. Crouch in the starting position (Fig. 13).

5. Pull the starter rope with a controlled and steady motion until the

unit starts.

6. Idle the engine for 30 seconds.

7. Squeeze and hold the throttle control or move the cruise control

to the HI (fast) position (Fig. 11).

NOTE: The engine is properly warmed up when it accelerates

without hesitation.

NOTE: Once the engine is properly warmed, the cruise control may

be adjusted and the throttle control can be used normally.

IF... the engine does not start after pulling the starter rope 10 times,

repeat the starting procedure.

IF... the engine is already warm: Squeeze and hold the throttle control

or move the cruise control to the HI (fast) position. Pull the starter

rope with a controlled and steady motion until the unit starts.

STOPPING INSTRUCTIONS

1. Release the throttle control, or move the cruise control to the

LO (slow) position, and allow the engine to idle.

2. Press and hold the On/Off switch in the Off (O) position until the

engine comes to a complete stop (Fig. 11).