Browser Configuration - Nilox DAS-1410 Manual De Instrucciones

LED
POWER Green light Lit up when power is plugged in and the system is ready. Red light Lit up during boot
DSL Green light Lit up when the device is successfully connected to an ADSL DSLAM
INTERNET Light off when WAN port fails to get IP address
Green light Lit up when WAN port gets IP address successfully. Blinking light when data transmit/received
Light off when the device is in bridge mode or when WAN connection is absent
LAN(1-4) Green light lit up when connected to Ethernet device
Blinking light when data transmit/received
WLAN Green light Lit up when the wireless module is started
The Led DSL, if suitably connected, will be flashing at first and then it remains on.
ATTENTION! The ADSL Led is OFF or blink continuously.
One of the most common causes of problem is bad cabling or ADSL line(s). Make sure that all connected devices are
turned on. On the front panel of your router you can see a bank of LEDs. Verify that the LAN Link and ADSL line LEDs are
lit up. If they are not, verify if you are using the proper cables. Make sure that all devices (e.g. telephones, fax machines,
analogue modems) connected to the same telephone line as your router have a line filter connected between them and the
wall outlet (unless you are using a Central Splitter or Central Filter installed by a qualified and licensed electrician), and that
all line filters are installed in a right way. If the line filter is not installed and connected properly, this may cause problems to
your ADSL connection or may result in frequent disconnections.
If the ADSL Led flashes periodically you must force modulation. Click on Setup->WAN, then ADSL. Please choose
ADSL modulation, then click on Apply Changes.
B C
ROWSER ONFIGURATION
Open the web browser, enter the local port IP address of this Wireless N ADSL2+ Router, by default this is at
192.168.1.1, and click Go to get the login page.
The default username is admin, password is nilox and click Login to continue. With the following steps you can make
Wireless Router ADSL2+ operate in short time using PCs in DHCP mode. Refer to the manual in the Installation CD if
you need personalized configuration. Click on Setup then WAN->WAN to select how the router will set up the Internet
connection.
For more detailed instructions on configuring and using the Router please refer to the online manual on CD-Rom.
Static IP address: this configuration is valid in case of a subscription with a static IP. Please check the manual on CD-
Rom.
MEANING
18
ENG